Boîtiers en Plastique

Easy assembly through snap-in installation of the case parts. Version: 9 poles (designed to allow the use of terminals, block 5.08). Supply: 1 pc each (max. number see enclosure).

Assembly unit: With bayonet lock, snapping into place. If required securing using 2 screws. Screw pillars for PCBs in bottom and top part. Screw pillars for battery compartment (acc.) in bottom part. Top part with recessed area for membrane keyboards. End piece (lid / battery compartment lid / base) required for bottom part - see separate article. Version: bottom part "level". Supply: 1 top and bottom part R110 F, assembly kit.

Snap-in. Supply: 1 front panel.

Enclosure with 2 sides open for connection - for max. 6 terminal guards (accessories). Fast and simple locking capability onto DIN EN 60715 (TH35). Bottom part with fastening pillars. Vertical and horizontal guides for assembling the PCBs. Easy assembly through snap-in installation of the case parts. Version II: front open*, connection side with free through passage, with ventilations slots. Supply: 1 bottom part, 3 clips, 1 top part. (*a ridge gives more stability during transport-easily

Snap-in. Supply: 1 front panel.

Enclosure with 2 sides open for connection - for max. 2 terminal guards (accessories). Fast and simple locking capability onto DIN EN 60715 (TH35). Bottom part with fastening pillars. Vertical and horizontal guides for assembling the PCBs. Easy assembly through snap-in installation of the case parts. Terminal guards, frame, front panel, front lid convex see accessories. Version II: front open, connection side with free through passage, with ventilations slots. Supply: 1 bottom part, 2 clips

The battery holder allows practically movement-free securing of the 2 x 1.5 V micro batteries, thus ensuring that the internal power supply is securely located in position. Supply: 1 battery holder, 1 self-tapping screw.

Design: Special holding clamp for SMART-CASE M , L and XL for attaching to tubes and corresponding suspensions. For fixing the preshaped centres in the bottom part have to be milled or punched. Supply: 1 holding clamp, assembly kit.

In combination with battery contacts A9166001 it's possible to have a bridge connection and therefore a serial connection. Supply: 1 battery contact.

Suitable for round knobs 40. Cover simply to pin up. Supply: 1 cover.